Note: this guide will show you how to load a multi-timbral instrument like Equator into Reaper.
Create an instrument track receiving on all channels, and load a multi-timbral plugin such as Equator.
Insert a virtual instrument on a new track. Select a multi-timbral plugin such as Equator and select the Seaboard RISE or GRAND as the input.
The Seaboard RISE and GRAND use multiple channels of MIDI to achieve polyphonic dimensions of touch. Reaper is very compatible with the Seaboard because it accommodates multiple MIDI channels on a single track which can host a multi-timbral plug-in like Equator.
Step 1: ROLI Dashboard Settings
Take a look at the MIDI and Pitch sections in the bottom-right and select:
- Channel Mode: Multi
- MPE: On
- Channel Range: 2 – 16
- You’ll see that the Global Channel is automatically set to channel 1.
- Pitch Bend Range: 48
Step 2: Create an Instrument Track
Open your Reaper project and insert a new virtual instrument track.
Insert ➝ Virtual Instrument on new track
Step 3: Add a new virtual instrument
A pop up window will open giving you the option to select the virtual instrument you wish to use.
In Reaper you are able to use VST and AU format plug-ins. As there is no particular advantage of using either, it is up to personal preference as to which one you choose. Navigate to your desired plugin (Equator) and click OK.
Step 4: Setup routing
Depending on the plug-in you select, you may see a message like this one:
Some multi-timbral instruments have multiple audio outputs. This message is asking if you would like to route those audio outputs to separate audio tracks.
In the case of the Seaboard the answer is almost always no. The Seaboard assigns each new note to its own channel, so separate audio outputs – which is most often used for drums – would be very confusing.
Step 5: Set Seaboard as MIDI input
All that’s left is to set the input of your instrument track to receive all MIDI channels from the Seaboard.
Click the input tab on that track and navigate to:
Input: MIDI ➝ ROLI – Seaboard ➝ All Channels
Step 6: Equator’s MIDI/MPE Settings
By default, Equator’s MIDI/ MPE Settings will already match those that we select for ROLI Dashboard in step one. But since a mismatch of settings in Dashboard and Equator can cause silent notes or incorrect pitching, it’s worth double-checking them now.
- Open the Equator plugin from your instrument track in Logic Pro X.
- Click on menu (☰) in the top right and select MIDI/MPE Settings.
- Ensure that Equator’s MIDI Settings match the ones we set in ROLI Dashboard in Step 1 (by default they should already be correct). Now that Equator is listening for MIDI on the same channels that the Seaboard is sending it, there will be no missing notes.
Step 7: Recording and Playback
You are now ready to use your Seaboard with a multi-timbral instrument in Reaper. Record-arm the track to enable MIDI input and record as normal.
Step 8: Editing
- Double click on the MIDI clip you have recorded to bring up the piano roll editor
- Use the drop down menu to the right of the controller lane to choose which controller you are seeing/editing (ie; pitch bend or channel pressure)
- Use the drop down menu on the bottom right of the controller lane to select which channel information you are seeing in the controller lane.